IBM PC 300GL

8. Press Esc until you return to the Configuration/Setup Utility program
menu.
9. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility menu and press Enter.
10. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Setting remote administration
You can remotely update the system programs, such as POST and BIOS,
from a network server by enabling remote administration. If you have set
an administrator password for your computer, the password does not have
to be entered in order to remotely update programs. Consult your network
administrator for information on setting up your network server to perform
POST and BIOS updates.
To set remote administration, follow these steps:
1. Start the Configuration/Setup Utility program. See “Starting and using
the Configuration/Setup Utility program” on page 29.
2. Select System Security and press Enter.
3. Select Remote Administration and press Enter.
4. To enable update remote administration, select Enabled. To disable,
select Disabled. Press Enter.
5. Press Esc until you return to the Configuration/Setup Utility program
main menu.
6. Before you exit from the program, select Save Settings from the
Configuration/Setup Utility program menu.
7. To exit from the Configuration/Setup Utility program, press Esc and
follow the instructions on the screen.
Chapter 4. Configuration/Setup Utility program 39