Note: To install a 3.5-inch drive into drive bay 2 (a 5.25-inch bay), you
must install a conversion kit. For information on purchasing a
3.5-inch conversion kit for a 5.25-inch bay, see your IBM reseller
or IBM marketing representative.
4. Install the drive into the bay. Align the screw holes and insert the two
screws.
5. If the drive you installed has nonremovable media (such as a hard disk
drive), replace the bay panel.
If the drive you installed is a removable media drive, place the bezel
frame that came with your computer over the drive bay.
Chapter 6. Installing options 79
To Next Page
Loading...
