IBM PCjr - Page 253

Diskette Drive Replacement 615
Warning: Be careful when the top cover is off the
system unit. The components on the power board
can become hot with the system unit On.
1.
Attach the diskette-drive mounting bracket to the
diskette drive (625).
2. Place the diskette drive into the bottom cover.
3. Slide the diskette drive to the the front until its
mounting bracket studs align with the holes in the
system board.
4. Gently press down on the back of the diskette drive
until the diskette drive is fuUy seated. DO NOT
PUSH ON THE CIRCUIT BOARD.
4-600-6 Diskette Drive