IBM PCjr - Page 373

Intermediate Gear Replacement 1467
1. Slide intermediate gear 0 ontoshaft.
2.
Replace retaining clip 0.
3. Place forms feedmotor 0 onto mounts.
4. Install two screws 0 but do not tighten.
5. Position forms feed motor to mesh gears with
minimum backlash 0 and no binding.
6. Tighten two screws.
7.
Replace top cover (1434).
8. Replace access cover (1430).
9. Replace forms rack (1440).
Graphics Printer 4-1400-41