23. Tighten the printer timing sensor locking screw and
recheck step 14. Realign if necessary.
Locking
Screw
24. Run the "Printer Offline Diagnostic Test" and
observe
the
speed
in
both
directions.
25. If the buzzer sounds the printer timing sensor board
is
set
incorrectly.
Repeat
the
procedure starting
at
step
18.
26.
If
the
speed
is
different
between
forward
and
reverse printing, perform
the
following steps.
a. Place positive
(+)
lead of the voltage meter on
the yellow wire solder coimection
on
the printer
timing
sensor
board.
b.
Loosen
the
printer timing sensor
board
locking
screw.
c.
Move
the
printer
timing
sensor
board
until
another up level location is observed and repeat
the
procedure
from
step
14.
27.
If
it is
the
same
speed
in
both
directions,
the
adjustment
is
complete.
Graphics
Printer
4-1400-47
To Next Page
Loading...
