Figure 41. Loosening the thumbscrews and removing the power midplane
d) Lift the power midplane by its bulkhead (C) and pull it out of the system. Refer to the previous
image.
e) Place the power midplane on an appropriate ESD surface.
20. Remove the system backplane.
a) Using a 4 mm Hex driver, loosen but do not remove the four captive screws (A) that mount the
backplane to the chassis. Refer to the following image for the location of the screws.
System backplane for the 9040-MR9
41
To Next Page
Loading...
