On the right pane, the Feature Code/Sequence Number value includes a dash (-) instead of a
decimal as shown on the ASMI welcome panel. For example, the ASMI welcome panel lists the
Feature Code/Sequence Number value as 78D3.001 while the right pane lists the Feature Code/
Sequence Number value as 78D3-001.
e. If the Enclosure serial number and Feature Code/Sequence Number do not match your notes,
update the values.
Note: If you update the value for the Feature Code/Sequence Number, be sure to include a dash
(-) instead of a decimal. For example, if your notes indicate the value for XXXX.YYY is 78D3.001,
you should specify 78D3-001 in the Feature Code/Sequence Number eld.
f. Click Save settings to update and save the Enclosure serial number and Feature Code/
Sequence Number.
19. Verify the installed part.
• If you replaced the part because of a service action, verify the installed part. For instructions, see
Verifying a repair (www.ibm.com/support/knowledgecenter/POWER9/p9ect/
pxect_verifyrepair.htm).
• If you installed the part for any other reason, verify the installed part. For instructions, see Verifying
the installed part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/pxhaj_hsmverify.htm).
Removing and replacing the system backplane in the 5105-22E, 9008-22L, 9009-22A, 9009-22G, 9223-22H,
or 9223-22S 123
To Next Page
Loading...
Need help?
General
