page 9.
5. Slide the mounting bracket (C) into the right slide rail until the spring-loaded pin snaps into place.
For details, see Figure 13.
6. Attach the mounting bracket (C) to the slot on the inside of the right slide by sliding the mounting
bracket (C) into the slide rail until the spring-loaded pin snaps into place. For details, see Figure 14 on
page 10.
Figure 12. Extending the pin, and installing the bracket into the slide rail
Figure 13. Installing the extension bracket into the slide rail
Installing the IBM Power System S822 (8284-22A) 9
To Next Page
Loading...
