IBM rack mount kit II - Page 6

Figures
1. Removing the cable cover, hinge cover, and stand cover ....................... 2
2. Removing the plastic cable clamp ..................................... 2
3. Removing the existing monitor stand from the monitor ......................... 3
4. Removing the hinges from the new monitor stand ........................... 4
5. Installing the hinges on the flat panel monitor .............................. 4
6. Installing the monitor on the new monitor stand ............................. 5
7. Installing the flat panel monitor in the keyboard tray .......................... 6
8. Storing the power supply and routing cables ............................... 7
9. Installing the cable cover, hinge cover, and stand cover ........................ 7
10. Comparing the new hinge cover to the old hinge cover ........................ 7
11. Routing the keyboard cable ........................................ 8
12. Installing the console switch mounting brackets ............................. 9
13. Installing the selector switch in the rack cabinet ............................. 9
iv  Copyright IBM Corp. 2001