17. Remove the Heat Sink from the SCM
Note: The heat sink MAY BE HOT.
a. One or more SCMs will need to be removed during this procedure. There are two versions of the
SCM removal tools available. The newest version has a "loop" for easier handling.
b. Loosen the heat sink actuation screw by turning the nut driver (P/N 46K5039) counterclockwise
(A) until the screw becomes loose and moves freely.
c. Grip the heat sink (B) by the grooves on opposing sides and remove it by lifting straight up.
d. Place the heat sink upside down on an ESD surface.
Note: If any dust/debris is to be removed from heat sink, it must be done in another room or
greater than 25 feet (7.62 meters) away from work area.
Remove SCM 13
To Next Page
Loading...
