m. Release the SCM
Note: To prevent the SCM from falling, do not squeeze the two tabs (B) before you place the
tool on the socket.
n. With the SCM and tool on the SCM socket, press down on the center button (A).
o. While pressing the button (A), squeeze the tabs (B) together.
p. Release the center button (A) while still holding the tabs (B) so that the tabs (B) are held in the
locked position.
Note: This will place the jaws (C) at the bottom of the tool in the open position, disengaging the
SCM from the tool.
q. Lift the SCM tool out of the system.
24 Power Systems: SCM
To Next Page
Loading...
