Avoiding System Resource Conflicts
Doing a Network Remote Program Load
To do a network remote program load (RPL):
1.
Using the PS2 command or ThinkPad Features program, check
that there is no conflict between the system resources used by
the PC Card and by other devices.
The following are the resources for a token-ring PC Card and an
Ethernet PC Card:
Token-Ring PC Card
IRQ 9
I/O Address (HEX) 0A20–0A23
Memory Address (HEX) CC000–CDFFF, D8000–DBFFF
Ethernet PC Card
IRQ 5
I/O Address (HEX) 0300–031F
Memory Address (HEX) D0000–D1FFF, D4000–D7FFF
IRQ5 is the default setting used by the Sound Blaster
emulation. To do an Ethernet PC Card RPL, change the
IRQ for the Sound Blaster emulation, or disable it with the
ThinkPad Features program or the SB PS2 command.
2.
Start Easy-Setup and select the Start Up icon.
3.
Select the Network icon.
A window appears at the bottom of the screen for you to select
the RPL speed.
4.
If you are using a token-ring card, select 4 (4Mbps) or 16
(16Mbps) for the RPL speed.
5.
Click on OK or press Enter; then restart the computer.
176 IBM ThinkPad 380 or 380D User's Guide
To Next Page
Loading...
