Storage Card Device Driver
/S:
n
Specifies the number of PC Card slots. /S:1 shows
that there is only one PC Card slot. When this
parameter is not set, the number of PC Card slots is
set to 2.
/P:
hhhh
Specifies the lower limit for the I/O address of the
ATA card. The device driver assigns the next usable
I/O address from this lower limit to the card. When
this parameter is not set, the device driver looks for a
usable address and assigns it to the card.
/EXIRQ:
n
Specifies the IRQ level that
is not
assigned to the
card. You can set more than one IRQ level.
/NOBEEP Specifies not to beep when a storage card is
installed. When this parameter is not set, you will
hear a beep every time a storage card is installed
into the PC Card slot.
/B Specifies that OS/2 has started from an ATA card.
When this parameter is set, there will be no
redundancy in assigning the logical drive to the slot
where OS/2 was booted. It depends on the ATA
card whether you can start OS/2 from it.
/STBTIME:
n
Specifies the time (from 1 to 21 minutes) until
entering standby mode. When the ATA card is not
accessed for the time specified by this parameter, the
ATA card enters standby mode (only when your ATA
card supports standby mode). When this parameter
is not specified, standby mode for the ATA card is
disabled.
/MDRV:
n
Specifies the number of extra drives that can be used
in addition to the number of PC Card slots available
for the PCMCIA storage devices. When this
parameter is not specified, no extra drive is given to
the device driver. The extra drives can be activated
by the PCMCIA ATA Card Mount Utility.
/!DM Specifies not to use OS2DASD.DMD as the device
manager. When this parameter is set,
OS2PCARD.DMD is used instead.
Appendix B. Advanced Information for PC Cards for OS/2 Warp 189
To Next Page
Loading...
