IBM ThinkPad 380 - Page 215

Appendix C. Using PS2 Commands
You can enter the following PS2 commands from the DOS and OS/2
command prompts to set the features for your computer. When
entering a command, enter it in the following syntax:
PS2 [ Parameter1 ][ Parameter2 ][ Parameter3 ]
Syntax Rules
Refer to these notes when you enter a command.
Syntax Rule
| Select one of the options on either side of the vertical
bar ( | ).
Highlighted Enter the exact highlighted letters in either uppercase
or lowercase.
UPPERCASE Enter any value for the following:
XX: 0–20 HH: 0–23
MM: 0–59 SS: 0–59
The MM (minutes) and SS (seconds) are optional. The
default values are 0.
lowercase Command elements in lowercase are optional. For
example, entering PS2 SE OF and PS2 SErial OFf gives
the same results.
Please note that PS2 commands are subject to change without
notice. If you enter a command written in this section and receive an
error, type PS2 ? and refer to the online help menu.
Copyright IBM Corp. 1996 195