Using CardWorks
Change card driver:
If this item is enabled (checked), you can select
either Plug and Play (if available) or the
CardWorks device drivers.
Remove from the Plug and Play hardware list:
If this item is enabled (checked), you can
delete the Plug and Play device driver assigned
to a card. This applies only if the card is
handled by Windows 95 (Plug and Play mode).
Later, when you reinsert the same PC Card,
CardWorks configures the card as if it were the
first insertion.
Memory Card Utility:
This item appears only if you insert an SRAM
card or a Flash memory card. You can format
the SRAM card or Flash memory card as
follows:
Note: You can also format these card from the
file system with the DOS FORMAT
command.
1.
Open the “PC Card Properties” window.
2.
Select Memory Card Utility tab.
3.
Enter a Volume Label (if desired).
4.
Click on Format Drive/Partition.
5.
Click on Start.
This procedure enables you to completely
erase a SRAM/Flash memory card, especially a
brand-new card. Make sure to save the data
on the card before erasing it.
Chapter 2. Operating Your Computer 71
To Next Page
Loading...
