2
Insert the ThinkPad Modem for Windows 95/98/NT Disk 1 into
the diskette drive.
3
Click on Start, and then Run....
4
Type A:\SETUP and press Enter.
| If the previous version of the driver is installed, the ThinkPad
| Modem setup program displays a message. Remove the
| previous version of the driver by using the uninstall tool
| provided in the ThinkPad DSP program. If the previous version
| of the driver is not installed, a message saying that Windows
| has found an unknown device appears. Insert the ThinkPad
| Modem for Windows 95/98/NT diskette into the diskette drive.
Follow the instructions on the screen.
Note: You need to set the dialing properties when using the
ThinkPad Modem functions. Click on Control Panel,
Modems, and then the Dialing Properties button.
For IRQ-sharing information, refer to Sharing an IRQ between
ThinkPad Modem Devices.
Disabling the Unnecessary CD-ROM Device Drivers for
Windows 95
This section describes how to disable the unnecessary DOS and
Windows CD-ROM device drivers.
If you installed Windows 95 on a blank hard disk drive without
DOS and Windows,
Windows 95 has automatically installed a
generic ATAPI CD-ROM device driver for your ThinkPad's
CD-ROM drive. You do not need to do the following procedure.
If you installed Windows 95 in a computer on which DOS and
Windows had been already installed,
you need to disable the
DOS and Windows CD-ROM device drivers to use the correct
Windows 95 generic ATAPI CD-ROM device driver.
To disable the DOS and Windows CD-ROM device drivers:
1
Start Windows 95 and go to the MS-DOS command prompt.
128 IBM ThinkPad 600E Online Book
To Next Page
Loading...
