To install Windows NT using an external CD-ROM drive, do the
following
1
Insert the Windows NT CD-ROM into the external CD-ROM
drive.
2
Go to the CD-ROM drive; then go to the \I386 directory.
For example, if your CD-ROM drive letter is D, go to D:\I386
3
At the command prompt, type WINNT; then press Enter.
For example, D:\I386>WINNT
Follow the instructions on the screen.
If your computer does not have a CD-ROM drive, use a network
server, you can install Windows NT on multiple computers by first
copying the Windows NT master source files to a shared drive on a
network server. After connecting your computer to a network, such
as with the DOS LAN requester, you can install the files from the
network server to your computer at the DOS command prompt.
For more information, refer to the Windows NT installation guide.
Note: If you have an external CD-ROM drive that connects under a DOS
environment, you can install Windows NT in DOS.
Installing the ThinkPad Configuration Program for Windows
NT
To install the ThinkPad Configuration program for Windows NT:
1
Start Windows NT, and log on with the user ID authorized as
an administrator.
2
Click on Start.
3
Click on Run..
Note: You can assign the directory in which the ThinkPad Configuration
program is installed. The ThinkPad Configuration program installer
does not support the use of a long name for the directory in which
the program is installed.
Chapter 8. Installing Software 131
To Next Page
Loading...
