Set whether to enter suspend mode when the LCD is closed:
Create the hibernation file:
Note: Use this command before using other hibernation
| commands. C – Z are the drive letters of the hibernation
| file is in.
Set the timer to enter hibernation mode after the specified
number of minutes (
xx
):
AC: Set the timer when the AC Adapter is connected.
DC: Set the timer when using battery power.
Set the timer to enter hibernation mode from suspend mode after
the specified number of minutes:
Set the timer to enter suspend mode after the specified number
of minutes (
xx
):
AC: Set the timer when the AC Adapter is connected.
DC: Set the timer when using battery power.
Note: If the AC or DC option is not specified, this command is
effective on the current power management mode set by
the PM command.
OFF | SUSpend — —
Cover Enable | Disable —
HFILE C – Z | DELete —
HTimer
xx
[AC | DC]
S2H 30 | 60 | 90 | Disable —
Appendix A. Using PS2 Commands 179
To Next Page
Loading...
