DC: Set the power management mode when using battery power.
Set POwer, LCd, DISK, SPeed, and STandby to their original values:
Note: This command is effective on the current power
management mode set by the PM command.
Set the power management mode to enter when a low-battery
condition occurs:
Note: Create the hibernation file using the HFILE command
before using the LB H command.
| Enable or disable an incoming call:
PMode High | Auto | Custom [AC | DC]
DEFAULT — —
LBattery Suspend | Hibernation —
RI Enable | Disable —
Serial Connector Commands
Set the features for the serial connector:
Set power on or off for the serial device attached to the serial
connector:
SERA Enable | Disable
ADDress
—
1 | 2 | 3 | 4
SErial ON | OFf —
Appendix A. Using PS2 Commands 181
To Next Page
Loading...
