TRACE OFF: The TRACE OFF instruction ends tracing as stated in the message
displayed at the beginning of interactive trace.
+++ Interactive trace. TRACE OFF to end debug, ENTER to continue. +++
You can enter the TRACE OFF instruction only during a pause while interactively
tracing an exec.
End the Exec: Interactive tracing automatically ends when the exec that initiated
tracing ends. You can cause the exec to end prematurely by entering the EXIT
instruction during a pause. The EXIT instruction causes the exec and interactive
tracing both to end.
TRACE ?: The question mark prefix before a TRACE option can end interactive
tracing as well as begin it. The question mark reverses the previous setting for
interactive tracing.
While interactively tracing an exec, you can also enter the TRACE ? instruction with
any operand to discontinue the interactive debug facility but continue the type of
tracing specified by the operand.
EXECUTIL TE: The EXECUTIL TE (Trace End) command ends interactive tracing
when issued from within an exec or when entered during a pause while interactively
tracing an exec.
For more information about the EXECUTIL command, see z/OS TSO/E REXX
Reference.
Debugging Execs
Chapter 9. Diagnosing Problems Within an Exec 117
To Next Page
Loading...
Need help?
General
