Need help?Do you have a question about the iBUYPOWER HYTE Revolt 3 and is the answer not in the manual?
General| Case Type | Mini-ITX |
|---|---|
| Color | Black |
| Material | Steel, Plastic |
| Motherboard Compatibility | Mini-ITX |
| Expansion Slots | 2 |
| Internal 3.5" Drive Bays | 1 |
| Internal 2.5" Drive Bays | 2 |
| Power Supply | Not Included |
| Maximum CPU Cooler Height | 140 mm |
| Power Supply Support | SFX |
| Cooling | Air |
| Front I/O | 1 x USB 3.2 Gen 1 Type-A, 1 x USB 3.2 Gen 2 Type-C, 1 x 3.5mm Audio Combo Jack |
Start by removing the rear panel by pulling from the bottom. The 4 side panels can be removed easily by hand.
Skip these steps if your Revolt 3 comes with its power supply pre-installed.
Remove the GPU cable cover and open the radiator door for access.
Install CPU, RAM, and M.2 devices before installing the motherboard into the case.
Complete as much cable management as possible before installing the CPU cooler.
Install storage drives and manage associated cables within the computer case.
Mount the CPU cooler onto the installed motherboard.
Install the graphics card, noting the top panel can be removed for larger cards.
Provides critical safety warnings regarding electrical hazards and proper installation procedures.
Details the warranty duration for the computer case and the power supply unit.
Explains how to obtain a full copy of the written warranty and contact information.
To Next Page