IC DYNAMICS
RS125
122706
PARTS LIST
WARNING
Remote start module
Four button transmitter
Ten wire harness
Six wires for power and ignition hook up
Three wire harness for optional door lock/unlock
Three wire harness for optional power trunk release/
factory alarm disarm/vacuum switch
LED
Service/program switch
Pin switch
Bullet connector for pin switch
Antenna
Antenna double faced mounting tape
Antenna extension harness
Installation instructions
Operating instructions
This Remote Car Starter is for vehicles with automatic trans-
missions and fuel injected gasoline or diesel engines only.
DO NOT install this Remote Car Starter in a standard stick
(manual transmission) or a vehicle that has a carburetor.
Serious personal injury or property damage could occur.
Never use the Remote Start on a vehicle that is in a garage
with the doors closed, an enclosed building, etc. Proper ven-
tilation is required to avoid serious personal injury.
Installation must be done by a qualified mechanic. We rec-
ommend that all connections be soldered.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
18
9am.– 5pm.
Central time
Monday – Friday
Log on anytime to
www.icdynamics.com
or Call 800-624-0500
Installation Questions?
REMOTE CONTROL CAR STARTER
INSTALLATION INSTRUCTIONS
Model RS125
IC DYNAMICS
®
With Keyless Entry and Power Trunk Release
To Next Page
Need help?
General
