Page 9
Fitting the rescue system into the inner container
The folded suspension lines are placed on the rescue chute as shown.
Use a packing thread to pull the rubber loop through the eyelets of the inner
container. The rest of the suspension lines are secured with the rubber loop.
Make a note of the date of packing in the pack control booklet.
Installing your rescue system
Most harnesses have a handle for the
harness containers. This handle must be
connected to the inner container.
The inner container of ICARO rescue
systems has two loops, in which the
handle of the harness can be attached
(center, side).
Handles for front and back containers are
generally suspended in the central loop,
container on side or under the seat, the
side strap used.
Note the instructions for the rescue unit in the operating instructions of your
harness.
If there is no handle of the harness or it does not fit with your inner
container, please ask the dealer of your harness or your paragliding school.
The handle must be firmly connected to the loop on the inner container
(opening strength < 70 N).
To Next Page
Loading...