Icer.ette 84 series User Manual

1
INSTALLATION, OPERATION, MAINTENANCE AND TROUBLESHOOTING
WARNING: Raritan Engineering Company, Inc. recommends that a qualified technician install, troubleshoot
and repair this product. Equipment damage, injury to personnel or death could result from
improper installation. Raritan Engineering Company, Inc. accepts no responsibility or liability
from damage to equipment, or injury or death to personnel that may result from improper
installation of this product.
WARNING: Refrigeration Equipment contains refrigerant fluids under very HIGH PRESSURE. Danger of
sudden pressure release may cause injury, death or severe frostbite resulting from not following
instructions.
CAUTIONS: DO NOT plug a 120 volt unit into a 240 volt power source.
DO NOT plug a 240 volt unit into a 120 volt power source.
DO NOT use a transformer to step down 240 volt 50 HZ power supply to 120 volt.
Equipment designed for 60 HZ may run slow on 50 HZ, resulting in inferior operation and possible
overheating of the motor(s).
WARNING: This device is not ignition protected. DO NOT install in compartments containing gasoline tanks
or in areas in which
ignition protected equipment is required.
INTRODUCTION
Model 84 and 85 Icer-ettes are CFC-Free automatic
icemakers designed and manufactured especially for
the marine environment. They produce up to 22 lbs
(10kg) of crescent shaped ice per day and can store 11
lbs (5kg). Model 84 is designed for installations
where less than counter height is available and the 85
is designed for counter height installaions. Each
model has a flush mount option which prevents the
door from extending beyond the cabinets. Installation
and maintenance are simple because no drain is
required and the thermostat is fixed; never needing
adjustment.
OPERATION
The Icer-ette's on-off switch is just beneath the door.
A unit begins to produce ice within 60 minutes after
start-up. Ice production stops automatically when the
bucket is full enough to interfere with the wire shut-
off arm. The unit should not be turned "off" with the
door closed and ice or water inside.
NOTES:
1. Due to fast freezing, ice cubes may appear
"cloudy". This is trapped air in the water and
does not affect the taste or quality of the ice.
2. "Hollow" ice cubes may result from fast-
freezing under certain climatic conditions such
as high humidity, etc. and is not an indication
of a problem with the icemaker.
MODEL 85
MODEL 84

Icer.ette 84 series Specifications

General

Brand	Icer.ette
Model	84 series
Category	Ice Maker
Language	English

Summary

Safety Information

General Warnings and Cautions

Covers qualified technician requirement, refrigerant pressure hazards, and electrical/ignition safety.

Product Introduction and Operation

Model Overview

Introduces CFC-free icemakers for marine use, covering production, storage, and model differences.

Operating Instructions

Details start-up, automatic ice production stopping, and notes on ice appearance.

Maintenance and Winterizing

Routine Maintenance

Guidance on cleaning the condenser, interior, and inspecting connections.

Winterizing Procedure

Steps for shutting off water, disconnecting lines, and preparing for storage.

Start-Up Procedure

Initial Power On Steps

Instructions for connecting water, checking leaks, and powering the unit on.

Installation

Mounting and Clearances

Details cabinet openings, built-in clearances, and level surface requirements.

Plumbing and Wiring Requirements

Covers water supply pressure, line details, and electrical power specifications.

Exploded Views and Wiring Diagram

Model 85 Exploded View

Diagram illustrating the parts of the Model 85 Icer-ette.

Model 84 Exploded View

Diagram illustrating the parts of the Model 84 Icer-ette.

Wiring Diagram

Schematic showing electrical connections for Icer-ette Series 84 and 85.

Parts List

Component Identification

Table listing part numbers for various components for different models.

Troubleshooting Guide

Problem Diagnosis and Correction

Lists common problems, possible causes, and recommended corrections.

Specifications

Performance and Dimensions

Details ice production, storage, water supply, AMP draw, and refrigerant charge.

Limited Warranty

Warranty Terms and Service

Outlines the one-year warranty, exclusions, and procedures for obtaining service.