08
Carrycot Set Up
a. The carrycot fabric should already be attached to the carrycot/seat unit frame.
PLEASE NOTE: The position of the carrycot may need to be adjusted to make
it level. This can be done by firmly pressing on the grey lever which can be
found at the top end of the frame.
a. Line up the holes on each side
before pushing firmly into place.
b. To remove, press the centre button
(A) inwards whilst pulling the bumper
bar upwards.
Step 1: Preparing the Carrycot
Step 2: Bumper Bar Installation
Recline Lever
A
To Next Page
Loading...
