Need help?Do you have a question about the Icom TV-R7000 and is the answer not in the manual?
Details the contents of the TV-R7000 package, including video cable and installation screws.
Remove two screws from the rear panel and slide out the unit's cover as shown in Fig. 1.
Attach the TV-R7000 cover to the side of the IC-R7000 using two supplied screws, as shown in Fig. 2.
After attaching the cover, secure the TV-R7000 unit to the cover using the previously removed screws.
Connect the TV-R7000 IF IN plug to the IC-R7000's 10.7MHz IF OUTPUT terminal.
Connect the supplied video cable from the TV-R7000 video output to a monitor's video input terminal.
Connect the supplied video cable from the TV-R7000 audio output to a monitor or TV set if needed.
Connect a suitable TV antenna, matching impedance for clear picture reception.
Turn on the power switches for both the IC-R7000 and the TV-R7000 units.
Push the [FM] MODE SELECT SWITCH and slide the FM SELECTOR SWITCH to [FM(2)] for 150kHz mode.
Tune the dial to the aural center frequency of the TV signal, not the picture carrier frequency.
Adjust the [AF GAIN] CONTROL on the IC-R7000 for a comfortable listening level.
Specifies the input frequency for the video carrier signal for US and European/Australian standards.
Specifies the input frequency for the audio carrier signal for US and European/Australian standards.
Specifies the intermediate frequency for the audio signal.
Defines the voltage output level for the video signal.
Defines the voltage output level for the audio signal with a specified load.
Details the required power supply voltage and polarity for the unit.
Specifies the approximate current consumption when no signal is received.
Provides the width, height, and depth of the unit, including projections.
States the total weight of the TV-R7000 unit.
To Next Page
General