iconBIT Toucan W Quick Start Guide Русский
7
Preparations before connecting:
1. Check the broad-band: 2M is the lowest requirement.
2. Router: router need to be included Dial-up and DHCP IP automatic acquisition, these two
functions.
Firstly, reset the router to the default settings, then set up an account and password, and make
sure DHCP IP automatic acquisition function has been opened.
Start to connect internet:
3. Cable network connection
(1) Connect cable network to LAN port of Toucan W, and connect the other end to LAN port of
r o u t e r.
(2) Power on Toucan W, click Settings->Networks, choose “Ethernet”, open and configure it.
There is a blue light and a flash yellow light when it works. If the yellow light flash slowly,
perhaps network can't be accessed, or it has not detected IP, please check the network.
As long as you open DHCP, Toucan W will detect IP automatically and connect to internet.
4. Wireless connection
Need to exit cable network connection before opening wireless.
(1) Click Settings-> Networks, choose Wi-Fi, open and configure it.
(2)When you connect a Wi-Fi successfully, there is a connection icon in status bar on the upper
right corner.
Open the web page: click earth icon, open browser.
To Next Page
Loading...
