ICONE X7 - Page 79

When using the display, pay attention to safety, do not disconnect / disassemble when
the power is turned on. Avoid using it in difcult weather conditions: rain, heavy snow
and strong sunlight. If the display fails, send it for repair as soon as possible.
Note
Power supply: 48 V
Nominal current: 30ma / 48V
Stop leakage current: <1uA
Screen specications: 3.5 “color TFT (480 * 320 pixels)
Communication method: UART (default setting)
Operating temperature: -20 °C ~ 60 °C
Storage temperature: -30 °C ~ 80 °C
Waterproof level: IP65
Technical data of the LCD display
Error code table:
ERROR CODE
ERROR DESCRIPTION VERIFICATION METHOD
07
08
09
11
12
13
14
21
22
25
30
Overvoltage protection
Failure of motor’s hall signal wire
Failure of motor’s phase wire
Failure of the controller’s temperature sensor
Failure of the current sensor
Failure of the temperature of the battery
Failure of the temperature of the motor
Failure of the speed sensor
Failure of the BMS communication
Brake lever failure
Communication failure
Check the battery voltage
Check the engine
Check the engine
Check the controller sensor
Check the controller
Check the battery
Check the engine
Check the position of the speed sensor
Check the battery
Quickly pull and release the brake levers
Check the controller connector