13
Owner’s manual for iCool Recovery Systems
The system will always reset to normal when you restart it.
When your screen rst starts up and the welcome screen appears a small warning notice may appear in the centre of the screen for one or two
seconds referring to the inter computer communication requirements, this is normal.
Emergency Override Provisions
Certain safety features in your iCool can be overridden in the event of a partial failure.
ICool systems are very reliable and have attained an excellent reputation around the world for this. In addition we have done all that we can in the
designs to build-in ways to work around any partial failure, so that you are not prevented from using your system for an important event. There
are some circumstances in which it would be acceptable to temporarily override certain safety systems that may become too sensitive and cause
trouble until they can be properly readjusted. This allows systems to continue to operate in circumstances where otherwise it might not be possible.
Of course we do not advise the overriding of electrical safety circuits.
For example, depending on the way your system has been set up, it sometimes occurs that the water flow monitoring system may be too sensitive
and will stop the pump because it appears that water is not flowing properly. We allow this to be over ridden if it becomes troublesome. Instructions
on how to do this will appear on the screen automatically if this happens. It must be remembered of course that if you disarm this system the pump
is no longer protected from running dry without water lubrication, so it is essential that you manually monitor the water flow. Our staff can assist
you by phone or e-mail to overcome most problems on the spot.
Failure of the Touch Screen
Even if a touch-screen fails or is damaged, we can usually still get you going.
In our efforts to remain the world’s number one supplier of mobile ice bath systems, we have continued to improve reliability, but we have also
engineered ways to ensure that no matter what happens in the eld, in most cases you can still use your iCool for that important event. Realistically,
even the best electronic systems occasionally have problems, especially in portable systems that have a relatively hard life and where water and
heat are involved. Fortunately, we have very few such problems, but as an added benet we have built into all iCool’s a complete manual override
system that allows your iCool to operate effectively even if parts of the electronics fail for whatever reason.
We do not publish this over ride information in the manual because it is a little different from model to model, but in the rare event that you ever
have a failure of the electronics or the touch screen which prevents you from operating your iCool, just call or e-mail the local iCool representative
in your country, or our international number or go to our web site and we will give you instructions on how to use the manual over ride facility on
your particular model.
At www.iCoolSport.com you will nd a listing of representatives around the world, or you can request a reply directly from our factory in Australia.
You will be contacted promptly and we will explain how to work around your problem until we can arrange repairs. This is an important service that
we hope you never need, but it’s good to know it is there. In addition to this service you will be pleased to know that your iCool is of a modern modular
design, which means that most components can be easily replaced in the eld and often by the owner.
UNDERSTANDING THE HEATING MODE PROTECTION CIRCUIT
For safety reasons you can only initiate the heating mode at the time the unit is rst switched on. You can not change to heating while you are using
it in the cooling mode. You must switch off at the main switch rst.
With TWIN models the other side heat pump can cool at the same time or both sides can heat or cool at the same time.
You must use a pool cover when heating the water.
We all understand heat rises and so you must use a cover on top of your pool when heating or you will lose a large amount of the heat energy into
the room and it will take much longer to heat the water.
If the status bar lights turn red when you start a cooling cycle.
It means you have inadvertently selected a temperature that is higher than the current pool water temperature. Switch off at the main power switch
to reset the computers and start again, this time set a temperature that is LOWER than the current pool temperature.
To Next Page
Loading...