I
JUKI – 3711P/3712
Pentium® III, Celeron™, VIA Cyrix®
Ⅲ
with
Ethernet, VGA/LCD
Ver 2.x
@Copyright 2000
All Rights Reserved.
Manual first edition March 7, 2000
The information in this document is subject to change without prior
notice in order to improve reliability, design and function and does not
represent a commitment on the part of the manufacturer.
In no event will the manufacturer be liable for direct, indirect, special,
incidental, or consequential damages arising out of the use or inability to
use the product or documentation, even if advised of the possibility of
such damages.
This document contains proprietary information protected by copyright.
All rights are reserved. No part of this manual may be reproduced by
any mechanical, electronic, or other means in any form without prior
written permission of the manufacturer.
Trademarks
JUKI-3711P/3712 is registered trademarks of ICP Electronics Inc., IBM
PC is a registered trademark of International Business Machines
Corporation. Intel is a registered trademark of Intel Corporation. AWARD
is registered trademarks of AWARD SOFTWARE INTERNATION, INC.
Other product names mentioned herein are used for identification
purposes only and may be trademarks and/or registered trademarks of
their respective companies.
II
Contents
Introduction.................................................................... 1
1.1 Specifications : ............................................................................... 2
1.2 What You Have.............................................................................. 3
Installation ..................................................................... 4
2.1 JUKI-3711P's/JUKI-3712's Layout.............................................. 5
2.2 CompactFlash Disk Master/Slave Mode ........................................ 6
2.3 Clear CMOS Setup......................................................................... 6
2.4 Inverter Power Select ..................................................................... 6
2.5 LCD Panel Shift Clock/Panel VCC Select ..................................... 7
2.6 Serial Port B(COM2) Mode select ................................................. 7
2.7 Serial Port B -- RI or External Power Select .................................. 8
2.8 CPU Fan Power Voltage Select...................................................... 8
Connection .................................................................... 9
3.1 Floppy Disk Drive Connector ....................................................... 9
3.2 PCI IDE Disk Drive Connector................................................... 10
3.3 Parallel Port ................................................................................. 11
3.4 Serial Ports .................................................................................. 11
3.5 Keyboard Connector.................................................................... 13
3.6 USB Port Connector.................................................................... 14
3.7 External Switch, Indicator and IrDA........................................... 14
To Next Page
Need help?
General