ICS, Blount Inc. • 4909 SE International Way Portland, OR 97222 USA • Tel 800.321.1240 • Fax 503.653.4393
© ICS, Blount Inc. • REV 0515 • f/n 545068
icsbestway.com
Page 1
(continued on page 2)
Page 1
(continued on page 2)
Quick Start Guide
Read before continuing
695GC / 695F4
READ OPERATOR’S MANUAL
FUELING THE SAW
BOX CONTENTS
WARNING
WARNING
CAUTION
• Read the operator’s manual carefully and understand the contents
before you use this equipment.
• Always wear protective clothing, including hard hat, eye protection,
hearing protection, respiratory protection and gloves.
• See operator’s manual for post use clean up and maintenance.
Always provide adequate ventilation when
handling fuel.
Use caution when handling gasoline.
Failure to use ICS® oil, or other high quality
2-stroke oil, may result in premature engine
failure and/or up to 90% reduction in engine life.
FUEL MIXTURE: 50:1 (2 %) gasoline/oil mixture
• Use premium unleaded gasoline with a minimum octane rating of 90.
• Add a small amount of fuel prior to adding oil to container, top off
with fuel for proper fuel/oil mixture, and shake the container.
• Always shut off the saw before fueling. Allow engine to cool off before
fueling.
• Thoroughly mix the fuel in its container before fueling.
• Slowly open the fuel cap to release any pressure that may have built-
up in the tank.
• Always fuel with saw laying on its side.
• After adding fuel, tighten the fuel cap carefully and secure with a
wrench.
50 : 1 (2%)
1 gallon : 2.6 oz.
5 liters : 100ml
:
FUEL CAP
To Next Page
Need help?
General
