ICS 680ES - User Manual

Other manuals for ICS 680ES

Service Manual80 pages

Questions and Answers

S
Stacy WilliamsAug 15, 2025
What causes chain breakage in ICS Chainsaw?
- L
  lunaaudreyAug 15, 2025
  One of the causes of chain breakage in ICS Chainsaw is improper chain tension. Adjust the chain tension.
W
wcooleyAug 18, 2025
Why won't my ICS 680ES Chainsaw start?
- D
  Denise PhillipsAug 19, 2025
  If your ICS Chainsaw won't start, several factors could be at play. First, the fuel might be old or of poor quality; in this case, replace it with fresh fuel. Another potential reason is a corroded or eroded spark plug, which should be replaced. Lastly, ensure that the multi-function lever is in the "RUN" position, not the "STOP" position.
E
edwardlopezAug 22, 2025
What to do if my ICS Chainsaw is difficult to start?
- H
  Holly BaileyAug 22, 2025
  There are a couple of reasons why your ICS Chainsaw might be hard to start. One common cause is a flooded engine. To resolve this, put the Multi-function lever in the middle position, hold the throttle on full with your foot, and pull the starter cord with hard, short, fast pulls until the engine starts. Another reason could be a fouled spark plug. If this is the case, remove the spark plug, clean it, and re-gap it to 0.5 mm (0.020 in).
S
smithjoseAug 25, 2025
Why is water not flowing to my ICS Chainsaw?
- U
  uericksonAug 26, 2025
  If water isn't flowing to your ICS Chainsaw, there are a couple of things to check: * Make sure the water hose isn't kinked and that the water supply is turned on. * Also, the water ports might be clogged with debris, so clear them out.
A
ashleyyatesAug 28, 2025
How to fix an ICS 680ES that won't reach full RPM?
- K
  Kevin OsbornAug 29, 2025
  If your ICS Chainsaw isn't reaching full RPM, the likely culprit is a dirty air filter. Try cleaning or replacing the air filter.
J
Joseph WaltonSep 1, 2025
Why is the chain speed slow on my ICS 680ES?
- A
  Aaron GreenSep 1, 2025
  If your ICS Chainsaw chain speed is slow, it could be due to chain tension that is too tight. The chain should always be able to be pulled around the guidebar by hand.
L
Linda PageSep 4, 2025
What causes chain tensioner breakage on an ICS Chainsaw?
- L
  Lisa ConwaySep 4, 2025
  Chain tensioner breakage on your ICS Chainsaw can occur if the side cover nuts aren't tight enough. Torque them to 27 Nm (20 ft-lbs). Also, avoid tensioning the chain when the side cover nuts are already tight.
J
Jeffrey RichardsonSep 7, 2025
What causes premature chain stretch in ICS 680ES Chainsaw?
- S
  Steven ParkerSep 7, 2025
  Premature chain stretch in an ICS Chainsaw can be caused by insufficient water pressure. The minimum water pressure required is 1.5 bar (20 psi).
A
Ashley Jones MDSep 12, 2025
What to do if my ICS 680ES Chainsaw has poor cutting speed?
- K
  Kevin RichardsSep 12, 2025
  To improve poor cutting speed on your ICS Chainsaw, make a few cuts in an abrasive material to expose the diamonds.