680ES OPERATOR MANUAL
26
© 2015 ICS®, Blount International Inc. Specications are subject to
change without notice. REV071315 F/N 577451
PRE-OPERATION SAFETY CHECKS
Operation
Perform the following safety checks each day to be sure that the safety features
designed into the saw are functioning properly. If any items are excessively worn or
damaged, replace before use.
• With the multi-function lever set to the “STOP” position, without starting saw,
pull starter rope slowly and inspect for fraying, wear and abrasion.
• Assure vibration isolators are intact.
• With engine running and without depressing thottle trigger lockout, pull throttle
trigger and assure continuous chain movement does not occur.
• Verify at engine idle speed that the chain does not move.
To Next Page
Loading...
