680ES OPERATOR MANUAL
24
© 2015 ICS®, Blount International Inc. Specications are subject to
change without notice. REV071315 F/N 577451
FUELING THE SAW
Fueling
Do not overll the fuel tank.
Should any fuel spill happen, wipe up the spillage and allow the rest to evaporate.
If fuel is spilled on yourself or your clothes, immediately remove contaminated
clothing and wash any part of your body that has contacted fuel with soap and
warm water.
Pressure can build up in the fuel tank and container and possibly cause sudden
release of fuel vapors when the tank is opened.
Open the fuel cap slowly and always provide adequate ventilation when
handling fuel.
After adding fuel, carefully install the fuel cap and tighten rmly by hand. Tip the
saw slightly to one side and check for leaks. Should any fuel leaks be
observed, do not start the saw.
Customers are encouraged to remain consistent in the fuel option they choose for
ICS saws. Alternating between options, such as going between traditional fuel to
Alkylate fuel (Aspen) and back again may have negative impacts on the engine.
CAUTION
To Next Page
Loading...
