680ES OPERATOR MANUAL
32
© 2015 ICS®, Blount International Inc. Specications are subject to
change without notice. REV071315 F/N 577451
Operation
To assure the best performance from your ICS saw, follow all safety precautions
and recommended techniques. Additional helpful information can be obtained at
icsdiamondtools.com.
CUTTING WITH THE SAW
CONCRETE/MASONRY CUTTING
Planning the Cut
1. Select the proper chain type for the material being cut. Refer to the chain
selection guide in this manual. See page 44.
2. Outline the cut with a permanent marker for a visual cutting guide.
3. Avoid pinching the guidebar and chain by using shims or other
anchoring devices to stabilize the workpiece. Always
plan to cut the bottom of an opening rst, then
top or sides. Save the easiest cut for last. (see
image at right)
4. Be sure cut concrete cannot fall and injure the operator
or bystanders. As the cut is being completed, assure that
appropriate bracing is in place to control the cut section
of the workpiece. Concrete is very heavy,
one cubic foot = 30 cm x 30 cm x 30 cm = 68 kg (12 in x 12 in x 12 in = 150 lbs)
22
1
3
To Next Page
Loading...
