If you have any questions, please call 1-800-558-4435
ICWUSA.com, Inc.
ELITE DOUBLE ARM INSTRUCTIONS - rev 03/31/2015 pjm
Page 1 of 3
ELITE DOUBLE ARM INSTALLATION
ATTACH WALL
PLATE TO WALL
Locate stud and mark top
hole, drill 11/64 pilot hole
and insert #14 screw and
tighten slightly. Using a
level, mark lower hole
and drill pilot hole, insert
#14 screw and, with
unit level, tighten both
screws. ICW supplies
#14 wood screws. If
installing onto metal
studs, you will need
to replace with proper
metal stud fasteners.
ATTACH TO DESK
Drill a 3/8 hole through the horizontal
surface you intend to mount to. Screw
the 3/8 stud into your desk mount
as shown, the stud is found in your
hardware bag.
Push the 3/8 stud on desk mount
through the hole in the desk and slip
the large mounting washer over the
stud from underneath and secure in
place with the 3/8 nylock nut.
Detach the pole mount from arm using the provided
5mm hex key. Separate the two sections of the
pole mount using the provided 5/32 hex key. Place
around the pole you are mounting to and rmly
reassemble the pole mount.
ATTACH TO POLE
If Mounting To Wall
If Mounting To A Desk If Mounting To A Pole
ATTACH ELITE ARM TO WALL MOUNT
Pass 3/8 bolt with bearing
assembly through wall mount
ear and into end of Elite
Arm. Secure Elite Arm over
wall mount using split lock
washer and nylock nut with
9/16 wrench provided and
5mm hex key.
Torque bolt down to 204 in/
lbs (17 ft/lbs)
9/16 wrench
(provided)
5mm
Black plastic beauty cap
Bearing
assembly
DANGER!
• Do not attempt to adjust your Elite arm until everything you intend
to mount to the arm is mounted.
• Arm must be completely horizontal (extended) before adjusting the
arm’s tension. Failure to do so will damage the arm and void the
warranty.
Never
• If equipment requiring AC power is mounted to this unit, have a
certiedelectricianinspecttheinstallation.
• Failure to install this unit according to these instructions will void
all ICW warranties. If installed incorrectly, ICW is not liable for any
damage or injury caused by the unit.
DO NOT use power tools to assemble or adjust the arm.
Use hand tools ONLY.
IMPORTANT
ICW recommends wood or metal stud mounting only.
MAXUMUM LOAD CAPACITY: 28 LBS (12.7 KG)
To Next Page
Need help?
General
