ID Photonics CoBrite Series - General Safety Precautions

____________________________________________________________________
CoBrite Mounting instructions CBDX-ACC-RM-x, CBDX2-ACC-RM-x
7
3 Mounting instructions
3.1 Side brackets
This section applies to all adaptor variants
Required tools:
• Hex driver 3.0
• Hex driver 2.5
• Hex driver 2.0 (only for CBDX-ACC-RM-2)
Attach Handles to custom aluminum parts using the supplied Hex screws with a hex
driver
Remove 2 Hex Screws located at one side panel of unit using a hex driver.
Do NOT remove screws at both sides at the same time!