ID Photonics CoBrite Series - Page 9

____________________________________________________________________
CoBrite Mounting instructions CBDX-ACC-RM-x, CBDX2-ACC-RM-x
9
CBDX-ACC-RM-1 and CBDX2-ACC-RM-1: Repeat the steps described above for the
other side of the instrument to complete the installation of the kit.
CBDX-ACC-RM-2 and CBDX2-ACC-RM-2: Perform the installation of the part on the
other unit to be mounted.
3.2 CBDX-ACC-RM-2 and CBDX2-ACC-RM-2: Installation of center plate
Once the side brackets are installed on each instrument remove 2 screws of the front
panel on the opposite side of the side brackets for each unit respectively (red
arrows).
DX:
DX2:
Now insert the center plate and use the same screws to fix it.