How to troubleshoot Ideal Clima Heating System unit that does not start up?
If your Ideal Clima Heating System unit doesn't start, first ensure it's receiving power by checking the power supply terminals. Also, the motor might be blocked, or the impeller clogged. In this case, turn off the unit, resolve any engine jams, clean the propellers, and then restart the unit.
Why is the air flow rate low in my Ideal Clima Heating System?
If you're experiencing a low air flow rate with your Ideal Clima Heating System, it might be due to a low speed setting; try selecting a higher speed. Another cause could be a dirty filter in either the fan or the exchanger. Clean or replace the filters, and also clean the fan and the recuperator.
What to do if the circuit breaker trips with Ideal Clima Heating System?
If the circuit breaker trips when using your Ideal Clima Heating System, it's likely due to a short circuit causing an overcurrent. Turn off the unit and contact a service center.
Why Ideal Clima Heating System Kers does not receive remote control?
If your Ideal Clima Heating System's Kers isn't responding to the remote control and there's no beep, first check that the remote control has batteries and that they are charged. Also, make sure the remote control is facing the "master" unit and check the dip-switches.
What to do if Ideal Clima Heating System Kers receives signals, but the fan doesn't spin?
If your Ideal Clima Heating System's Kers is receiving signals but the fan isn't spinning, it could be because the front panel hasn't fully opened; wait 40 seconds for it to open. Alternatively, the Kers might be in "control" mode; try changing modes with the remote control. Finally, the fan might be blocked; try unlocking it.
Why Ideal Clima Heating System Kers does not receive signal while the red led is on?
If your Ideal Clima Heating System's Kers isn't receiving any signal from the remote control and the red LED is on, the filters may need cleaning or replacement. Clean or replace the filters and reset using the "reset filters" button. Also, check that the remote-control batteries are not low.
Why Ideal Clima Heating System Kers works only in ejection mode?
If your Ideal Clima Heating System's Kers is only working in ejection mode and the red LED remains on, the set humidity threshold might be too low. Raise the desired humidity level using the "humidity" key.
What does it mean when the red led on Ideal Clima Heating System SLAVE unit blinks?
If the red LED on the SLAVE unit of your Ideal Clima Heating System is blinking, it indicates incorrect connections or dip switch settings. This could mean the master-slave connection is interrupted.
General| DHW Production | Yes |
|---|---|
| Efficiency Class Heating | A++ |
| Heating Output (kW) | 5.0 |
| Refrigerant | R32 |
| Fuel Type | Electric |
| Mounting | Wall-mounted |
| Power Supply | 230V |
| Type | Air-to-water heat pump |
To Next Page