Figure 1
TECHNICAL INFORMATION
BEFORE YOU START
● Before commencing installation, carefully remove packaging/protective film and check for
damage. If damaged, report immediately to supplier.
● Check the packs and make sure that you have all parts listed. If not, contact the supplier.
● Ensure the water feeds and waste connection points are positioned appropriately for the
installation.
● Care should always be taken when drilling into walls and floors to avoid any sunken wires
or pipes.
● The bath should be fully protected during the installation process.
● Please note: Although these instructions are comprehensive, it is always recommended
that a technically competent installer should undertake installation.
Appropriate safety equipment/workwear should be used
All dimensions shown in millimeters.
Dimensions shown may vary within permitted tolerances.
To Next Page
Loading...