10. Replace with the one piece front controls channel and
secure with 6 screws (located in casing assembly pack).
7. Position Master Module and level feet using a 13mm spanner. Check module with spirit level.
IMPORTANT. ENSURE MODULE IS LEVEL IN BOTH DIRECTIONS TO ENSURE SATISFACTORY ASSEMBLY.
9. Remove 4 screws on each control box support
channel and discard channels.
8. Position Slave Module to LH side of Master Module (ensuring not to disturb levelled Master Module) and
repeat levelling process.
10
ASSEMBLING THE MODULES .... CONTINUED
INSTALLATION
To Next Page
Loading...
