LED Indicators
After following the above, the drone lights will then flash as in the below diagram. These lights are
the ones located on the UNDERSIDE of the Drone.
NOTE:
It is recommended to check the drone telemetry (on your phone & APP Screen) including calibration
status when you encounter an error
When the drone voltage is too low, (red LED flashing)
“Armed” below Means the Drone has just been Powered On – but not yet ready for take-off. It is
recommended to ONLY Takeoff when lights are “SLOW BLUE FLASHING” and under GPS Hover
Mode.
Please do not attempt to fly this drone on low battery (lower than 22V). The battery should always be
fully charged.
To Next Page