idronaut Ocean Seven 316 Plus CTD - User Manual

idronaut Ocean Seven 316 Plus CTD

142 pages

Save Page as PDF

To Next Page

To Next Page

Loading...

Table of Contents

Questions and Answers

M
Mrs. Julie MontesAug 3, 2025
How to fix idronaut Measuring Instruments when there is no communication with the probe?
- J
  Jacob PopeAug 3, 2025
  If you're having trouble communicating with the idronaut Measuring Instruments probe using ITERM or REDAS-5, first try communicating with the RS232C laboratory cable if you are working with telemetry. Ensure the battery and/or power supply are functioning correctly. Verify that the communication port selected in the software aligns with the hardware interface where the cable is connected. If using battery or external power, make sure the probe is switched on via the magnetic switch. Try closing and restarting the ITERM program. If you are working with REDAS, attempt communication using the ITERM program.
M
Megan PotterAug 12, 2025
What to do if the measurement cycle cannot be stopped on idronaut Ocean Seven 316 Plus CTD?
- P
  Philip BensonAug 12, 2025
  If the measurement cycle was started in non-verbose mode, use the ITERM program’s “Stop Cast” function to halt it. Alternatively, run ITERM, switch on the probe, and when data appears on your screen, press the key and answer to the prompt to stop the measurement cycle.
A
Amy VegaAug 25, 2025
What to do if data cannot be stored in memory of idronaut Ocean Seven 316 Plus CTD Measuring Instruments?
- C
  cclarkAug 25, 2025
  Most of the time, initializing the memory solves this problem with idronaut Measuring Instruments.

idronaut Ocean Seven 316 Plus CTD Specifications

General

Brand	idronaut
Model	Ocean Seven 316 Plus CTD
Category	Measuring Instruments
Language	English