Quick Guide Filon FUTURE charger Rev. 1.05 3
Functioning
Start charging process
To start charging, connect the charger to the battery and then to the mains.
The charger automatically starts the charging process and executes the charge independently.
Equalizing charge
Filon FUTURE chargers use the patented Filon FUTURE
charging characteristic to charge
flooded batteries. This charge profile consists of a main charging phase followed by a dynamic
pulse charge phase with a dynamic dU/dt switch-off that does not require additional equaliza-
tion.
Stop charging process
When the battery is 100% charged,
the charger automatically stops the charging process and
the green LED lights up.
To disconnect the fully charged battery from the charger, first disconnect the charger f
power supply and then disconnect the battery from the charger.
The fully charged battery can now be used again.
Charge retention
If the battery is not disconnected from the charger after the charging process has been com-
pleted, the charger switches to charge retention. In this state, self-
discharge is prevented so
that the battery's state of charge is kept.
Note
A prerequisite for a fully charged battery is an uninterrupted charging process. Any interruption
of the charging process may result in capacity loss and premature failure of the battery.
To Next Page
Loading...