The information contained in this document is the property of Automatic Systems and is confidential. The recipient shall refrain from using it for any purpose other than the use of the products or the
execution of the project to which it refers, and from communicating it to third parties without Automatic Systems’ prior written agreement. Document subject to change without notice.
BL3x-MT-EN-08 page 2/59
Revision page
Rev Date Written by Checked by Nature of the modification
02 Jan 25, 2007 MFy SD+JB - Replacement of D1 control board by AS1320 (version
3.6 of the program) => ch 4 added.
- Addition of reinforcement stop (ch. 6.6).
03 July 17, 2007 MFy - Update of the balance table (ch 6.5).
04 Nov. 09, 2007 MFy - Adapt to software version 4.1 of AS1320 control
board (ch 4).
- Addition of electric diagrams for options (ch 8).
- Update of the conformity certificates (ch 10).
05 Jun 18, 2008 MFy - Control board: adapted to version 6.x of the program.
- Revision of the electric diagram & addition of
connector blocks assignment.
06 July 3, 2008 MFy
Ch.8.1: adapt the detection loops pinning references to
electric drawings (X9-X11-X13-X14).
07 2009-07-30 MFy
Ch. 2.4: operation t° modification.
Ch. 10: EC certificate update.
08 2009-08-20 MFy
"Safety warnings" chapter: add warning regarding the
use of the crank.
To Next Page
Loading...