The pellets are
stacked into the
combustion bowl,
cover glass gets dirty
very quickly and the
flames are burning
low.
comes insufficient combustion air.
Check that it is edible by the boiler room constantly
fresh air.
The pellets could not damp or
appropriate.
Smoke extractor engine may be
damaged.
Check the gutters clean and clear the air duct of the
combustion bowl.
Clean the Make a general cleaning of the combustion
chamber and smoke channel.
Check that the cover adheres wick.
Check that sits right on the location of the pellet
burning dish.
Change the type of pellets.
Replace the flue fan motor to the checks did not
work.
Chimney Smoke
evacuation fan
motor is not
running.
Furnaces electric welded may also be
problems.
Check the feeding phase and voltage electrocuted.
Fan motor may be damaged.
Replace if necessary to check the motor capacitor.
The electronic card may be defective.
The control panel can be broken.
Change the electronic motherboard.
Replace the control panel.
To Next Page
Loading...
