Need help?Do you have a question about the Igloo MWC529 and is the answer not in the manual?
Carefully remove the water dispenser from its packaging, including strapping, foam, and plastic bag.
Wipe down the outside of the water dispenser with a soft, damp cloth before placement.
Place on a level surface, away from direct sunlight and heat, ensuring proper ventilation space.
Do not plug in the dispenser or turn on power until after reading all instructions.
Place bottle vertically, then open taps to purge air until water flows, ensuring proper seal.
Plug into a grounded outlet and switch on the power. Allow time for warming if unit is cold.
Includes cleaning the exterior, no-spill system, tanks, and interior with recommended solutions.
Clean interior periodically (1-3 months) based on water hardness and bottle changes.
Check power connection and ambient temperature; allow unit to warm up if cold.
Ensure unit is on a level surface. Resetting may help if noise persists after initial use.
Ensure adequate ventilation around the unit; a hot radiator is normal during compressor operation.
Adjust thermostat downwards. Avoid frequent starting and stopping of the compressor.
Verify the refrigeration thermostat is set correctly; it may be set too warm.
Check for calcium deposits in taps or ensure the drain plug and rubber seal are secure.
Carefully remove the water dispenser from its packaging, including strapping, foam, and plastic bag.
Wipe down the outside of the water dispenser with a soft, damp cloth before placement.
Place on a level surface, away from direct sunlight and heat, ensuring proper ventilation space.
Do not plug in the dispenser or turn on power until after reading all instructions.
Place bottle vertically, then open taps to purge air until water flows, ensuring proper seal.
Plug into a grounded outlet and switch on the power. Allow time for warming if unit is cold.
Includes cleaning the exterior, no-spill system, tanks, and interior with recommended solutions.
Clean interior periodically (1-3 months) based on water hardness and bottle changes.
Check power connection and ambient temperature; allow unit to warm up if cold.
Ensure unit is on a level surface. Resetting may help if noise persists after initial use.
Ensure adequate ventilation around the unit; a hot radiator is normal during compressor operation.
Adjust thermostat downwards. Avoid frequent starting and stopping of the compressor.
Verify the refrigeration thermostat is set correctly; it may be set too warm.
Check for calcium deposits in taps or ensure the drain plug and rubber seal are secure.
General| Color | White |
|---|---|
| Water Temperatures | Hot, Cold, Room Temperature |
| Dispensing Options | Push Button |
| Power Consumption (Cooling) | 80W |
| Heating Capacity | 5L/h (≥85°C) |
| Material | Plastic |
| Capacity | 5 Gallon |
| Voltage | 120V |
To Next Page
