EasyManua.ls Logo

Ignis ADL448 User Manual

Ignis ADL448
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
EN -1-
Chart
PROGRAM SELECTION
BUTTON
Push “Programs” button
(repeatedly) until the indicator
of the required program lights
up (see “Table of programs”
below).
CANCEL/OFF BUTTON
Push this button to switch off the control panel.
If pressed when a program is running it cancels the
program ongoing draining water for 1 minute.
If pressed when the dishwasher is switched off it
drains any possible liquids from dishwasher
(1 minute process).
If the indicator flashes repeatedly, see
page 6 - chapter ”What to do if ...”.
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle push the Start button
and close the door within 3 seconds.
1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “contact_ignis@ignis.com”.
*Power consumption in: Left-on mode: 0.70 W / Off mode: 0.40 W
Table of programs
Deter-
gent
Consumption
Drying
Phase
P
Programs Loading instructions
Litres kWh
Minutes
1)
1
Pre-Wash cold
Crockery to be washed later. 5.0 0.02 10 NO
2
Rapid 40°C
Lightly soiled crockery, with no dried-on
food.
X 13.0 0.70 30 NO
3
Eco
2)
50°C
Normally soiled crockery.
“Standard program” the most efficient in
terms of its combined energy and water
consumption.
X 15.0 1.02 165 Full
4
Intensive 65°C
Recommended program for heavily soiled
crockery, especially suitable for pans and
saucepans.
X 15.0 1.50 140 Full
5019 550 00321
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
Quick reference guide
Ignis is a registered trademark
Question and Answer IconNeed help?

Do you have a question about the Ignis ADL448 and is the answer not in the manual?

Ignis ADL448 Specifications

General IconGeneral
BrandIgnis
ModelADL448
CategoryDishwasher
LanguageEnglish

Summary

Initial Setup and Water Hardness

First Time Use Setup

Instructions for initial setup and water hardness adjustment.

Detergent Suggestions by Water Hardness

Guidance on choosing detergent based on water hardness levels.

Filling the Salt Reservoir

Step-by-step guide on how to fill the salt reservoir.

Daily Salt Check

How to check salt indicator and reservoir levels.

Rinse Aid and Detergent Usage

Rinse Aid Adjustment and Indicators

How to adjust rinse aid dosage and check indicators.

Detergent Dispenser Guide

Instructions for adding and using detergent.

Loading the Dishwasher Racks

Upper Rack Adjustments and Loading

Adjusting upper rack height and removing it for loading.

Lower Rack Loading and Features

Loading the lower rack and using removable lateral support.

Maintenance and Fault Rectification

Filter Cleaning and Maintenance

How to check and clean the filters for proper operation.

Spray Arm Maintenance

How to remove blockages and clean spray arms.

Troubleshooting Appliance and Dish Issues

Appliance Not Starting or Indicating Errors

Covers scenarios where the appliance won't start or shows error lamp blinks.

Crockery Cleaning Problems

Addresses issues with dishes not being clean or having food residues.

Troubleshooting Crockery and Cutlery Problems

Salt Indicator and Residue Issues

Addresses lit salt indicator and regeneration salt residue.

Drying and Appearance Issues

Covers drying, discoloured plastic, and glass appearance problems.

Safety and General Precautions

General Safety Warnings

Important safety instructions for operation and child safety.

Disposal and Environmental Advice

Guidelines for safe disposal and compliance with WEEE directive.

Related product manuals