iHome iB12 - User Manual

CR1625X2
Model:iB12(Front)
Printcolor:Blacktextonwhitepaper
Sizeofmanual:130Wx220H(mm)
Date:Jul31,2013
Model: iB12
Using Your iHome Headphones
The earpieces are marked “L” and “R”. Place the “L” earpiece in your left ear
and the “R” earpiece in your right ear for proper fit and best sound. If the
earpieces are inserted incorrectly they will not fit properly in your ears and the
sound quality will not be satisfactory. For added stability the cables of these ear
buds should be looped over your ears as shown in the following illustration.
NOTE: Your iB12 headphones are supplied with three different size silicon tips
(S-M-L) for maximum comfort and to seal out unwanted noise. The “M”
(medium) size tips were installed at our factory. If you find that the installed tips
are too small or too large for your ears, you may remove them and replace
them with the larger or smaller size accessory tips. To replace the tips simply
pull them off the earpieces. To install different size tips, push them on to the
earpieces and make sure they are fully seated on each earpiece so that they do not come off when you
remove the earpiece from your ear. If one of the tips remains in your ear when you remove the
headphones, remove the tip carefully and avoid pushing it further into your ear canal. Seek medical
assistance if one of the tips becomes lodged in your ear and you are unable to remove it.
Connect the headphone plug to the headphone jack of your music player. Be sure that the plug is fully
inserted into the jack. If the plug is not fully inserted you may only hear sound from one earpiece.
To protect your hearing, always start listening with the volume control of your music source set to a low
level and then gradually increase the volume to a comfortable listening level.
LED Safety Flasher
Your iHome iB12 Ear Buds are supplied with a
LED safety flasher that includes a convenient
belt clip and an integrated cord wrap to keep
your cables tangle free. Remove the battery
pull tab before use.
Press the Mode Button on the front panel to
turn the flasher on and cycle through the 3
operating modes as follows:
First press – LED’s flash rapidly
Second press – LED’s flash slowly
Third press – LED’s ‘On’ continuously
Fourth press – LED’s ‘Off’
Replacing Batteries
Two CR1625 batteries that were installed at our factory should provide sufficient power for up to 96 hours
of continuous operation. When the lighting effect begins to dim or no longer turns ‘On’ you should replace
the batteries as soon as practical.
fitness earbuds
with clip-on LED safety flasher
+ cordwrap
Slide-out
Cord Wrap
Mode
Button
Battery
Compartment
Remove the battery
pull tab before use
To open, unscrew center screw
only and pull out the batteries tray
Install two fresh CR1625 batteries
in the battery tray as shown above
+
LITHIUM BATTREY
CR1625
3V
-
+
+
-
-
-
+
Belt Clip
Press here to open belt clip

Summary

Using Your iHome Headphones

Wearing and Fitting Earbuds

Properly fit L/R earpieces with optional tips for comfort and sound quality.

Connecting and Safe Listening

Ensure plug is fully inserted and start listening at low volume to protect hearing.

LED Safety Flasher Operation

Flasher Features and Cord Management

Features a belt clip for attachment and integrated cord wrap for tangle-free storage.

Activating and Cycling LED Modes

Use the Mode Button to cycle through flash rapid, flash slow, and continuous on modes.

Replacing the Batteries

Battery Specifications and Life

Uses two CR1625 batteries providing up to 96 hours of operation.

Battery Replacement Procedure

Unscrew center screw, remove tray, and insert new batteries correctly.

Important Safety Information

Cord Management and Visibility

Utilize cord wrap for tangle-free cables and clip for visibility during activities.

Hearing Damage and Warning Sounds

Avoid high volume listening; be aware of surroundings as noise isolation blocks warning sounds.

Static Electricity Sensation

Experiencing a slight 'tingling' is normal due to static electricity build-up.

Limited One-Year Warranty

Warranty Coverage and Service

Warrants product free from defects for one year; contact customer service for repair/replacement.

Return Authorization Process

Follow steps for return authorization, packing, proof of purchase, and shipping.

Warranty Disclaimer and Legal Rights

Excludes damage from misuse; states warranty validity and limitations on damages.

iHome iB12 Specifications

General

Connectivity	Bluetooth
Microphone	Yes
Frequency Response	20Hz - 20kHz
Impedance	32 Ohms
Charging Time	2-3 hours
Wireless Range	33 feet (10 meters)
Driver Size	40mm
Foldable	Yes
Color Options	Black