Quick Start Setup
1
Download and open the iHome Control app from the App Store or Google Play.
Plug the SmartPlug into a desired outlet. The LED will start blinking to indicate it
is ready for setup.
Tap Add Device ... in the Devices tab and follow the on-screen directions to
complete setup.
When prompted, scan or type the Accessory Setup Code below:
Success! You should now be able to toggle your SmartPlugs ON or OFF from the
iHome Control app or by using Siri®.
Alternative method for iOS: Go to your device WiFi settings and connect to
“iHome SmartPlug xxxxx”. Configure it to your preferred WiFi network. Then
re-open the iHome app and proceed from Step above.
1
2
3
3
4
5
NOTE: When typing, dashes are not required
To Next Page
Loading...
